The Enlighted Fixture Mount Control Unit (CU) interfaces with Enlighted sensors and ballast or LED driver to intelligently control light behavior.
Control Units Spec Sheets
-
Fixture Mount Control Unit (CU-4E-FMH) for 0-10V drivers
The CU is mounted inside an enclosure.
-
Nipple Mount External/Internal Control Unit (CU-4E-NME/NMI) (North America only)
Intended for field installations, mounted on the side in the junction box using the nipple, or mounted outside of the fixture. Two versions are available, NME (Nipple mount external), where the sensor is external to the fixture, NMI (Nipple mount internal). the sensor is mounted internal to the fixture.
-
Fixture Mount Control Unit for DALI drivers (CU-4D-FM) (Europe only)
In support of our traditional 8-pin sensors and enabling hardware energy metering of traditional DALI drivers, the Fixture Mount Control Unit for DALI drivers is available ONLY in the EU countries accepting the CE mark. Please note that the Control Unit for DALI incorporates the DALI PSU, so there is no need to procure a separate PSU. The Control Unit for DALI does NOT support Tunable White (DT8) or Emergency Lighting (DT1) functions, but it has the ability to meter energy.
View files below to download the spec sheets:
-
Nipple Mount External Control Unit (CU-4A-NME-16A)
The CU-4A-NME-16A is a robust control unit designed specifically to handle 347 VAC inputs. This control unit provides two channels for dimming or digital commands, each with buffered output. The unit is compatible with the Enlighted Sensor Interface (ESI) and features a single-pole single-throw (SPST) continuous duty coil, operating within a 16A load range.
Recommended articles
Install Guides
Drivers
Other reference articles for CUs
FAQs
