The table below lists the 0-10V Profile 0 dimming LED drivers that have been verified as compatible with Enlighted's Gen 5 sensors as of March 31, 2021.
The Profile 0 drivers listed below have an auxiliary DC output that can be used to power the sensor directly without the need for a Control Unit. These drivers do not have a hard energy metering capability, so they should only be used when hard energy metering is not required.
Note: The drivers listed in the following table are not the only list of compatible drivers and controllers that can work with the Enlighted IoT system; these are examples of some of the products available in the market that Enlighted has tested and used in previous projects. Also, because these are not Enlighted products, Enlighted has only performed the functionality verification that the Enlighted IoT system would need and no further. The Enlighted needed features set may only represent a subset of what the drivers can do in applications not covered by the Enlighted IoT system feature set. Therefore, we recommend that the fixture designer evaluate the drivers' full performance, reliability, and conformance to safety, electrical code, and other industry standards that the fixture needs to meet.
Output Current (mA): These drivers indicate a range in the output current column. this means that these drivers feature programmable max current output, and this max current setting needs to be properly programmed. The level of current to be programmed depends on the fixture designed max lumen output and also the maximum operating current a LED light engine can sustain.
Note the drivers with Red Fonts: These drivers indicate a range in the output current column. this means that these drivers feature programmable max current output, and this max current setting needs to be properly programmed. The level of current to be programmed depends on the fixture designed max lumen output and also the maximum operating current a LED light engine can sustain.
