Push Profile Update to a Sensor

When a light profile is modified and saved, it is automatically pushed to all sensors that use the modified profile. However, when there are many sensors, it might take a while for all sensors to be updated. 

To verify if a modified profile has been pushed to a sensor, either double-click the sensor on the floor plan display or click on the Edit button for the sensor in the Facilities > Devices > Sensors menu item.


In the resulting Fixture details pop-up, select the Profile tab.

If the Push Profile button is grayed, the configuration information has been pushed to the sensor. If the button is blue, the information has not yet been sent to the sensor. Click the blue Push Profile button to schedule the push to occur immediately. Likewise, repeat the procedure for each sensor to check if the updates have been pushed to the sensors or not.


Recommended articles:

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Article is closed for comments.